American Standard 0115.808 Indoor Furnishings User Manual


  Open as PDF
of 1
 
J15
© 2008 AS America Inc.
COLONY™ 21"
PEDESTAL SINK
VITREOUS CHINA
NOTES:
*
DIMENSIONS SHOWN FOR LOCATION OF SUPPLIES AND “P" TRAP ARE
SUGGESTED.
▼ ANCHOR SCREWS FOR PEDESTAL NOT INCLUDED.
INSTALLATION INSTRUCTIONS SUPPLIED WITH LAVATORY.
■ SUITABLE FOR REINFORCEMENT ONLY, ACTUAL DIMENSIONS MUST
BE TAKEN FROM FIXTURE.
FITTINGS NOT INCLUDED AND MUST BE ORDERED SEPARATELY.
PROVIDE SUITABLE REINFORCEMENT FOR ALL WALL SUPPORTS.
IMPORTANT: Dimensions of xtures are nominal and may vary within the
range of tolerances established by ANSI Standard A112.19.2.
These measurements are subject to change or cancellation. No responsibility
is assumed for use of superseded or voided pages.
184 mm
(7-1/4)
102 mm
(4)
95 mm
(3-3/4)
470mm
(18-1/2)
457 mm
(18)
540 mm
(21-1/4)
PEDESTAL ANCHORING
SCREW HOLES
8 mm (5/16) DIA.
FINISHED
WALL
REF.
375mm
(14-3/4)
267mm
(10-1/2)
114mm
(4-1/2)
864mm
(34)
749mm
(29-1/2)
584 mm
(23)
533 mm
(21)
FINISHED
FLOOR
SUPPLIES AS
REQUIRED
27mm x 14mm
(1-1/16 x 5/16) SLOTS
203 mm
(8)
203 mm
(8)
S-9 HANGER
1-1/4 O.D.
WASTE
1-1/4 O.D.
TAILPIECE
13 mm
(1/2)
191 mm
(7-1/2)
178 mm
(7)
*
*
ANCHOR BOLT HOLES
(REQUIRED FOR SECURE
INSTALLATION)
10 mm (3/8) DIA.
DRAIN
CHASE
OPEN
TO
FLOOR
PEDESTAL
SIDE SECTION
To Be Specied:
❏ Color: ❏ White ❏ Bone ❏ Linen ❏ Silver
❏ Faucet:
❏ Faucet Finish:
❏ Supplies:
❏ 1-1/4" Trap:
COLONY™ 21" PEDESTAL SINK
• Vitreous china lavatory and pedestal
• Front overow
• Fitting ledge with generous shelf area
• Supplied with mounting kit
Shown with 2385.060 Reliant faucet
(not included)
❏ 0115.411 Faucet holes on 4" (102mm) centers
(Illustrated)
❏ 0115.811 Faucet holes on 8" (203mm) centers
Nominal Dimensions:
552 x 470 x 864mm
(21-3/4" x 18-1/2" x 34")
Separate Components:
❏ 0115.404 Pedestal top 4" (102mm) centers
❏ 0115.808 Pedestal top 8" (203mm) centers
❏ 731100-400 Pedestal only
Bowl sizes:
445mm (17-1/2") wide
292mm (11-1/2") front to back
127mm (5-1/2") deep
Compliance Certications -
Meets or Exceeds the Following Specications:
• ASME A112.19.2M for Vitreous China Fixtures
Revised 2/08