Filter
Top Products
Installing Exhaust Hose to Window Slide Bar
After assembling Innovative AutoDrain NanoMist Technology
™
per instructions on page 5,
make sure hose is fi rmly attached to oval connecter that fi ts into window slide bar.
Snap hose connecter into window slide bar opening. See Illustration 1.
Extend window slide bar to fi t your window opening, either vertical or horizontal,
depending on how the window opens. See Illustrations 2a-2b.
Important
The fl exible exhaust hose can be extended from 12" to 60" for mounting.
This length has been designed especially according to the specifi cations of the
air conditioner.
Do not use an extension or exchange for a different hose as that may lead to
malfunctioning.
The exhaust air must fl ow freely, any blockage can lead to overheating of the air conditioner.
Take care to prevent any kink or bend in the exhaust hose.
This unit can easily be moved from one room to another. In doing so keep this in mind:
• The air conditioner must stand upright on an even surface.
• Do not position near bath, sink, or other permanent wet or damp area.
• Keep unit at least 18" from wall, curtains, draperies, to insure adequate air circulation.
1
2
b
2
a
Positioning
5 6
Put spiral water
pipe into hot air
fl exible hose.
Connect the
female half of the
quick connector
at the end of the
spiral water pipe
to the male part
in the hot air
outlet pipe.
Turn the
connector
90º clockwise
until it is locked
in place.
Stretch end of
the hose slightly.
Assemble the hot
air hose on the
unit by screwing
in clockwise.
Clip on the
water atomizer
at the end of
the spiral pipe
to the holder.
Unfold fl exible
hose with attached
hose adapter
connector, and
snap into
Window Slide Bar.
Only
Required For
Disassembly.
In order to
unlock the quick
connector, push
the tab and turn
the connector
90º clockwise.
AutoDrain NanoMist Technology
™
Assembly
2
3
6
8
4
5
7
1
Stretch end of
the hose slightly.
Attach Window
Slide Bar
Connector to
Exhaust Hose by
twisting as shown.