Filter
Top Products
Leg Frame, Left & Right Tabletop
(shipped in separate box)
Back Panel Storage Shelf
Please Note: Back Panel and Storage Shelf are identical and interchangeable.
Rear Extension Tubes
WorkMaster
™
& WorkMaster Jr.
™
Tools required: Phillips screwdriver and drill with
1
⁄
8
" drill bit.
Assembly Instructions
Parts Included:
A 2pcs
B 1pc
C 1pc D
1pc
E 2pcs
F 2pcs
G 4pcs
H 4pcs
I 24pcs
J 1pc
To Assemble:
Unpack and inspect contents to confirm you have all parts listed above.
Fasten floor glides (G) into bottom of leg frames at each
end as shown in Figure 1.
Place back panel (
C) on a bench or table at least 20"
high with ends hanging over the edge.
Hang left leg frame (
A) on top of back panel as shown in
Figure 1. Make sure ends of back panel are snug against
steel leg frames and holes are aligned in steel flange
with pre-drilled holes in back panel. Attach using four
5
⁄
8
"
screws (I) supplied. Repeat step for right leg frame.
Figure 1
Carefully remove base assembly from table/bench and place
upright on floor.
Place shelf (D) with predrilled holes facing up on the bench/table with
ends hanging over edge. Lift base assembly carefully (may require two
people) and set on top of shelf. Balance with care. Align holes in steel
flange with predrilled holes in shelf and insert
5
⁄
8
" screws (I) making
sure ends of shelf are snug against steel frames
(see Figure 2)
. Tighten
securely, but use care not to overtighten and strip.
Remove base assembly carefully from table/bench and place
upright on floor.
Figure 2
Cardboard
Template
5
⁄
8
" Screws
Floor Glide
5
⁄
8
" Screws
1
2
3
4
5
6
Front Extension Tubes
Floor Glides
Height Adjustment Knobs
#10 x
5
⁄
8
" Wood Screws
Tabletop Template