Filter
Top Products
16
E: OPERATION AND ADJUSTMENT INSTRUCTIONS
HOW THE DOOR MOVES WHEN THE OPENER IS ACTIVATED
Always keep moving door in sight and away from people and objects until it is completely closed
NO ONE SHOULD CROSS THE PATH OF A MOVING DOOR.
IF THE DOOR IS...
...FULLY OPEN, then pushing the standard wall Push Button or the radio control will cause the door to begin MOVING
DOWNWARD.
...FULLY CLOSED, then pushing the wall Push Button or the radio control will cause the door to begin MOVING UPWARD.
...MOVING UPWARD, then pushing the wall Push Button will cause the door to STOP. The next push of the wall button will
cause the door to begin MOVING DOWNWARD (Alternate Action Operation).
...MOVING DOWNWARD, then pushing the wall Push Button or the radio control will cause the door to STOP. The next
activation will cause the door to BEGIN MOVING UPWARD.
...MOVING DOWNWARD and an obstruction is encountered, the door will STOP, PAUSE AND REVERSE TO THE OPEN
DIRECTION.
...MOVING UPWARD and an obstruction is encountered, the door will STOP. The next activation will CLOSE the door.
The SAFE FINISH PHOTOELECTRIC uses an invisible beam which, when broken by an obstruction, causes a closing door to open
and prevents an open door from closing.
HOW THE LIGHT WORKS AND WHAT IT MEANS WHEN IT FLASHES
1. The convenience light automatically turns on when the opener is activated and remains on for 4-1/2 minutes for your convenience
and safety.
2. The light will flash after coming upon an obstruction in the down direction to alert you of a problem. It will continue to flash for
4-1/2 minutes, then shut off.
3. Optional Wall Station adds the convenience of allowing the light to be turned on and stay on until turned off by a second push of
the button or
activation of door cycle.
If the light begins to flash and the door does not move in the close direction from a push button or radio, the
external safety device (Safe Finish Photoelectric) is activated or defective (misaligned or blocked etc.). To
temporarily override and close door, activate pushbutton or wall station for 2 seconds; opener will begin moving
in the down direction. The button must remain depressed until the cycle is completed. If the button is released
before cycle is completed, the door will reverse and come to a fully open position. Problems with the safety system
should be inspected by a professional garage door installer.
HOW TO OPERATE THE DOOR MANUALLY - MANUAL RELEASE DISCONNECT
The door should be fully closed, if possible, before using the manual disconnect. Weak or broken springs
could allow an open door to fall rapidly. Property damage or serious personal injury could result. Do not
use the manual release handle to pull the door open or closed.
Your opener is equipped with a manual release recessed trolley-type disconnect
system, enabling manual operation of the garage door during a power failure.
The trolley is disconnected from the chain by pulling down on the red release
handle, allowing the garage door to be operated manually.
The trolley will automatically reconnect when power is restored and the door is
activated.
If the manual release is used, close the door before reactivating the opener.
NOTE: Outside keylock manual releases are an available accessory and are recommended for garages without a service
entrance.
110058-1
Trolley
Manual Release Knob