Filter
Top Products
14
D: CONTROL AND AUXILIARY EQUIPMENT
WARNING
WARNINGWARNING
WARNING
TO PREVENT THE RISK
OF PERSONAL INJURY,
DAMAGE TO DOOR OR
PROPERTY, ONLY
OPERATE DOOR
CONTROLS WHEN DOOR
IS IN CLEAR VIEW. KEEP
REMOTE CONTROL
AWAY FROM CHILDREN
IN SECURE AREA.
104386
Setting The Coding Switches: When setting the Coding Switches THE FACTORY
PRE-SET CODES MUST BE CHANGED TO PREVENT UNAUTHORIZED
OPERATION. Transmitter and Receiver codes must be set IDENTICALLY. If just
one Code Switch is mismatched, the Radio Controls will not function.
NOTE: For security reasons, it is advisable NOT to set all the switches in the
same position.
Mounting The Receiver: After setting the Coding Switches, mount the Receiver on
the rear panel of the Opener by connecting it to Terminals 1, 2 and 3. For proper
operation, the Antenna Wire should be POINTED STRAIGHT DOWN toward the
floor.
After installing the Radio
Controls, check their operation
by moving approximately 35
FT away from the garage door
and pressing the Transmitter
Button. Operation at this
distance should be reliable.
If the Transmitter doesn't
activate door operation, check
that all Coding Switches are set
identically. If the operational
distance is inadequate, try
moving the position of the
Transmitter in the car. If the distance is still inadequate, try bending the Antenna Wire
to a different angle. If the distance is still
inadequate, replace the Battery with a standard 9-
Volt “transistor radio” Battery (NEED 1604). The
Battery is located in the front compartment next to
the Coding Switches.
The Transmitter may be hand held if desired by
removing the Visor Clip from the rear of the Case
as illustrated. Place your finger in the loop at the
top of the visor, and your thumb on the top edge
of the Transmitter. Push down with your thumb
and pull up with your finger. The clip will release
and pull out easily.
CODING BLOCK: Transmitter and
Receiver Coding Switches are contained
in identical Coding Blocks, consisting of
nine small switches, labeled 1 - 9, each
of which can be set in any of three
positions, labeled +, 0, -
POINT ANTENNA
STRAIGHT DOWN
108386
104388
INSTALLATION OF RADIO CONTROLS:
The following instructions detail installation of Model 9931 Radio Controls. For other Radio models, see instructions
packaged with product.
104385
TRANSMITTER:
To gain access to
the Transmitter
Coding Switches,
remove the Battery
Cover from the
front of the
Transmitter by
sliding it toward the
bottom of the
Transmitter as
illustrated.
104384
RECEIVER: The
Receiver Coding
Switches can be
accessed by
removing the small
door from the back
of the
Receiver using a
small screwdriver or
knife.