Filter
Top Products
18" PEDESTAL FAN
18" (45.7 cm) MODEL 9418
1
Rev. A 11/05
5084034
DESCRIPTION
The AirKing 18" (45.7 cm) pedestal fan features 3-speed rotary knob
operation with a 3-paddle fan blade and variable height adjustments.
This fan has a permanently lubricated motor with a 9 ft. (2.74 m) 18/3 cord
set and is constructed of sturdy, powder coated steel.
SPECIFICATIONS
Motor.......................................120 V, 60 Hz
Blade diameter .......................18" (45.7 cm)
Speeds....................................3
Control ....................................Rotary Switch
Air flow distribution .................360°
Approvals................................UL Listed. Close mesh fan guard
meets OSHA requirements.
ASSEMBLY
TOOLS REQUIRED FOR ASSEMBLY
• Hex Wrench (Supplied in Parts Bag)
NOTE: ALL HARDWARE REFERRED TO IN THE INSTRUCTIONS MAY
BE FOUND IN THE SUPPLIED PARTS BAG.
1. Lay Fan Head on flat surface, so the front side is facing down. Hold Yoke
so the side with the n ut is facing up. Loosely attach one Grill Knob and
one Rubber Spacer to the Head Assemb ly. Attach the other Gr ill Knob
and Rubber Spacer to the Head Assembly and FIRMLY tighten. Return to
the first Grill Knob and FIRMLY tighten.
(Figure 1)
NOTE: THE UPPER PIPE HAS 2 BUMPS, ONE AT EACH END. THE BUMP
CLOSER TO THE END OF THE PIPE INDICATES THE TOP. THIS END
FITS INTO THE YOKE.
2. Make sure Bump on Upper Pipe is aligned with formed section of Yoke.
Insert Upper Pipe into Yoke. To ensure fit is tight, twist Upper Pipe until it
is tight inside of Yoke.
(Figure 1)
NOTE: THE UPPER PIPE SHOULD FIT COMPLETELY INSIDE OF THE YOKE.
GENERAL SAFETY INFORMATION
When using electrical appliances, basic pr e-
cautions should always be followed to reduce
the risk of fir e, electric shock and injur y to
person, including the following:
1. Read all instructions before using Fan.
2. Make certain that the power source conforms to the electrical
requirements of the Fan.
3. Use this Fan only as described in this manual. Any other use
not recommended by the manufacturer may cause fire, electrical
shock, or injury to persons.
5. Unplug power cord before installing, servicing, or moving the Fan.
WARNING: DO NOT DEPEND UPON THE ON-OFF
SWITCH AS THE SOLE MEANS OF DISCONNECTING
POWER WHEN INSTALLING OR SERVICING THE FAN.
ALWAYS UNPLUG THE POWER CORD.
6. This Fan must NOT be used in potentially dangerous
locations such as flammable, explosive, chemical-laden
or wet atmospheres.
7. The power cord is equipped with a three-prong grounded plug
that must be inserted into a matching receptacle. Under no
circumstances must the grounding prong be cut off the plug.
Where a two-prong wall receptacle is encountered, it must be
replaced with a properly grounded three-prong receptacle
installed in accordance with the National Electrical Code
(NEC) and all applicable local codes and ordinances. This
work must be done only by a qualified electrician, using copper
wire only.
WARNING: USE OF A THREE-PRONG TO TWO-PRONG
ADAPTER IS NOT RECOMMENDED. IMPROPER CONNEC-
TION MAY CREATE THE RISK OF ELECTROCUTION. USE
OF SUCH ADAPTERS IS NOT PERMITTED IN CANADA.
WARNING: THIS PLUG IS A SAFETY FEA TURE. TO
REDUCE THE RISK OF FIRE, ELECTRIC SHOCK AND
PERSONAL INJURY, DO NOT REMOVE, REPLACE,
REPAIR OR TAMPER WITH THE ORIGINALLY SUPPLIED
PLUG. IF THE FAN DOES NOT FUNCTION PROPERLY,
IT MAY BE DUE TO THE SAFETY DEVICE
INCORPORATED IN THIS PLUG. RETURN TO AN
AUTHORIZED SERVICE CENTER OR CALL 800-233-0268,
MONDAY - FRIDAY, BETWEEN 8:00 AM AND 5:00 PM EST.
IF THE PLUG WARNING LABEL IS MISSING OR
DAMAGED, CALL THE TOLL FREE NUMBER FOR A
REPLACEMENT LABEL.
8. Where possible, avoid the use of extension cords. If they must
be used, minimize the risk of overheating by ensuring that they
are UL listed. Never use a single extension cord to operate more
than one Fan.
9. Do not operate any Fan with a damaged cord or plug after the
Fan malfunctions, has been dropped or damaged in any manner.
Return Fan to authorized service facility for examination, electrical
or mechanical adjustment or repair.
10.Do not inser t or allow fingers or f oreign objects to enter an y
ventilation or exhaust opening as it may cause an electric shock,
fire, or damage the Fan. Do not block or tamper with the Fan in
any manner while it is in operation.
11.Always place the Fan on a stable, flat, level surface when
operating, to avoid the chance of the Fan overturning. Locate
the Power Cord so the Fan or other objects are not resting on it.
Do not run Power Cord under carpeting. Do not cover Power
Cord with throw rugs, runners, or the like. Arrange Power Cord
away from room traffic and where it will not be tripped over.
12.This Fan is not intended for use in wet or damp locations.
Never locate a Fan where it may fall into a bathtub or other
water container.
13. Do not use Fan outdoors.
WARNING: REDUCE THE RISK OF FIRE OR ELECTRIC
SHOCK – DO NOT USE THIS FAN WITH ANY SOLID STATE
SPEED CONTROL DEVICES.
READ AND SAVE THESE INSTRUCTIONS
READ CAREFULLY BEFORE ATTEMPTING TO ASSEMBLE, INSTALL, OPERATE OR MAINTAIN THE PRODUCT
DESCRIBED. PROTECT YOURSELF AND OTHERS BY OBSERVING ALL SAFETY INFORMATION. FAILURE TO
COMPLY WITH INSTRUCTIONS COULD RESULT IN PERSONAL INJURY AND/OR PROPERTY DAMAGE!
RETAIN INSTRUCTIONS FOR FUTURE REFERENCE.
OPERATING INSTRUCTIONS & PARTS MANUAL
SAVE THESE
INSTRUCTIONS