Filter
Top Products
MODEL
4TM64A/9515A
SPEED
HIGH MED LOW
CFM 3285 2830 2210
M
3
/s 1.55 1.34 1.04
RPM 1220 1050 750
Amps 1.10 .80 0.62
Watts 115 95 75
dB A 55 50 44
RETAIN INSTRUCTIONS FOR FUTURE REFERENCE.
READ AND SAVE THESE INSTRUCTIONS
READ CAREFULLY BEFORE ATTEMPTING TO ASSEMBLE, INSTALL, OPERATE OR MAINTAIN THE PRODUCT
DESCRIBED. PROTECT YOURSELF AND OTHERS BY OBSERVING ALL SAFETY INFORMATION. FAILURE TO COMPLY
WITH INSTRUCTIONS COULD RESULT IN PERSONAL INJURY AND/OR PROPERTY DAMAGE!
DESCRIPTION
The AirKing 15" (38.1 cm) Deluxe Pivot Fan features 3 speed whisper-
quiet operation, a 5-paddle fan blade and 120° adjustable tilt. The fan
has a permanently lubricated motor with a 6 ft. (1.8 m) 18/3 cord set.
1
2084534Rev. A 6/99 (Motor)
15 INCH DELUXE PIVOT FAN
15" (38.1 cm) MODEL 4TM64A/9515A
OPERATING INSTRUCTIONS & PARTS MANUAL
GENERAL SAFETY INFORMATION
1. Make certain that the power source conforms to the electrical
requirements of the fan.
2. The power cord is equipped with a three-prong grounded plug that
must be inserted into a matching receptacle. Under no circum-
stances must the grounding prong be cut off the plug. Where a two-
prong wall receptacle is encountered, it must be replaced with a
properly grounded three-prong receptacle installed in accordance
with the National Electrical Code (NEC) and all applicable local
codes and ordinances. This work must be done only by a qualified
electrician, using copper wire only.
WARNING: USE OF A THREE-PRONG TO TWO-PRONG ADAPTER
IS NOT RECOMMENDED. IMPROPER CONNECTION MAY CRE-
ATE THE RISK OF ELECTROCUTION. USE OF SUCH ADAPTERS
IS NOT PERMITTED IN CANADA.
3. Where possible, avoid the use of extension cords. If they must be
used, minimize the risk of overheating by ensuring that they are UL
listed and of the proper gage and length. Never use a single
extension cord to operate more than one fan.
4. Do not insert fingers or foreign objects into the fan. Do not block or
tamper with the fan in any manner while it is in operation.
5. Unplug power cord before installing or servicing the fan.
WARNING: DO NOT DEPEND UPON THE ON-OFF SWITCH AS THE
SOLE MEANS OF DISCONNECTING POWER WHEN INSTALLING
OR SERVICING THE FAN. ALWAYS UNPLUG THE POWER CORD.
6. This fan is intended for general use ONLY. It must NOT be used in
potentially dangerous locations such as flammable, explosive,
chemical-laden or wet atmospheres.
WARNING: TO REDUCE THE RISK OF FIRE OR ELECTRICAL
SHOCK, DO NOT USE THIS FAN WITH ANY SOLID STATE SPEED
CONTROL DEVICE
OPERATION
1. ADJUSTABLE TILT: To adjust direction of air, simply turn the
head of the fan. The 120° ratchet adjustment will securely snap
and hold the fan in the desired position.
2. SPEED: Speed is controlled by three position rotary switch
located on rear of fan.
3. POWER SUPPLY CORD: Plug power supply cord into a wall
outlet (AC 120 volts, 60 Hz).
THE RACHET ASSEMBLY ON THE 15" DELUXE PIVOT FAN IS
DESIGNED FOR POSITIVE LOCK POSITIONING. THEREFORE
WHEN ADJUSTING THE FAN ANGLE A LOUD CLICKING SOUND
IS NORMAL.
MAINTENANCE
WARNING: ALWAYS UNPLUG THE CORD BEFORE SERVICING.
CLEANING: Use a soft cloth and a mild soap solution such as liquid
dish washing detergent.
CAUTION: Do not use gasoline, benzine, thinner, harsh cleaners,
etc. which will damage the fan.
Dry all parts with a soft cloth completely before reconnecting to power
supply.
STORAGE: When not in use, keep unit in a clean dry place.
MOTOR IS PERMANENTLY LUBRICATED.
SPECIFICATIONS
Motor...................................120V, 60 Hz
Blade Diameter...................15" (38.1 cm)
Speeds................................3
Control ................................Rotary Knob
Air Flow Distribution ...........120° Variable
Approvals............................UL listed. Close mesh fan guard meets
OSHA requirements.
4
MODELO 4TM64A/9515A
2084534
Rev. A 6/99 (Motor)
MANTENIMIENTO
ADVERTENCIA: DESCONECTE SIEMPRE EL CORDÓN ANTES DE
INTENTAR REALIZAR CUALQUIER FUNCIÓN DE SERVICIO.
LIMPIEZA: Use un trapo y una solución de jabón suave, tal como
detergente líquido para lavar trastes.
ADVERTENCIA: No use gasolina, bencina, diluyente de pintura ni
limpiadores fuertes en aerosol, ya que éstos dañarán el ventilador.
ALMACENAMIENTO
: Cuando no lo utilice, mantenga el aparato en
un lugar limpio y seco.
EL MOTOR HA SIDO PERMANENTEMENTE LUBRICADO.
PARTES DE REPUESTO
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
15
14
13
12
17
19
19
18
18
16
20
Ref. No. de Parte Descripción Cant.
21
1 2010788 Cubierta del Motor (Trasera) 1
2 2010793 Botón del Interruptor 1
3 2090039 Tornillo de #8 x 3/8 Tipo 25 PPH 2
4 2091108 Tornillo de #8 x 3/4 Tipo AB HWH 5
5 2010786 Rejilla Trasera 1
6 2010790 Accesorio de Inserción de la Manija 1
7 2057067 Interruptor 1
8 2090710 Tornillo de #10 x 1/4 Tipo B 1
9 2050044 Cordón Eléctrico 1
10 2010949 Cubierta del Interruptor 1
11 2031229S Conjunto del Motor 1
12 2010791 Trinquete 2
13 2010789 Horquilla 2
14 2091115 Arandela Planas 1 x .205 x .062 2
15 2091116 Tornillo de #8 x 5/8 Tipo 25 HWH 2
16 2010794 Hélice 1
17 2010792 Base 1
18 2090038 Tornillo de #8 x 9/16 Tipo 25 PPH 2
19 2010414 Pie 4
20 2010785 Rejilla Delantera 1
21 2091109 Tornillo de #6 x 3/4 Tipo 25 PPH 2