Filter
Top Products
– 15 –
$UPLQJWKH6\VWHP
$UPLQJ& RP PD QGV
Before arming, close all perimeter doors and windows and make sure the Ready to Arm
message is displayed.
Mode Press these keys… Touchpad Confirms By…
Stay security code + [3] (STAY)
• three beeps
• armed STAY message displayed
• red ARMED indicator lights
Night-Stay security code + [3] + [3]
• three beeps
• NIGHT-STAY message displayed
• red ARMED indicator lights
Instant security code + [7] (INSTANT)
• three beeps
• armed STAY message displayed
• red ARMED indicator lights
Note that entry delay is turned off.
Away security code + [2] (AWAY)
• beeping for duration of exit delay
• armed AWAY message displayed
• red ARMED indicator lights
Leave the premises through an entry/exit
door during the exit delay period to avoid
causing an alarm. The touchpad beeps
rapidly during the last 5 seconds of the
exit delay to warn you that it is ending.
Quick Arming
If "Quick Arming" was programmed by the installer, the
[#]
key can be pressed in
place of the security code when arming the system. However,
the security code
must always be used to disarm the system.
Function Key Arming
For any arming command, a function key may have also been programmed for your system. If
so, you can press and hold the appropriate function key for 2 seconds to arm the system. See
your installer for the designated functions (see
Single Button Arming
section).
Refer to the
Accessing Other Partitions
section for information on multi-partiion
arming.