Filter
Top Products
– 12 –
(QWU\([LW' HOD\V
Your system has preset time delays, known as exit delay and entry delay.
([LW'HOD\
Exit delay gives you time to leave through the designated exit door without setting
off an alarm. Exit delay begins immediately after arming your system in any
arming mode and Custom Display touchpads display the message “You May Exit
Now.”
When “You may exit now” disappears, the system is fully armed.
If programmed, a
slow beeping will sound throughout the exit delay period.
Exit Delay Restart.
If you wish to open the entry/exit door to let someone in after arming
STAY, you can re-start the
exit
delay at any time –
simply press the
[
✱
]
key
, then let that
person in. This avoids having to disarm the system and then re-arm it again.
(QWU\'HOD\
Entry Delays give you time to disarm the system when you re-enter through the
designated entrance door. But you must disarm the system before the entry delay
period ends, or an alarm will occur. The touchpad beeps during the entry delay
period, reminding you to disarm the system. There are two entry delays (if
programmed). The first is for your primary entrance and the second can be used for
a secondary entrance, where a longer delay is required to walk to the touchpad to
disarm the system.
You can also arm the system with no entry delay at all by using the INSTANT
arming mode. This mode provides greater security while on the premises or while
away for extended periods of time.
See your installer for your delay times.
Partition 1 __________________________________________________________
Exit Delay:
seconds Entry Delay 1: seconds
Entry Delay 2:
seconds
NOTE: Entry/Exit times set for partition 1 also apply to the common zone.
Partition 2 __________________________________________________________
Exit Delay:
seconds Entry Delay 1: seconds
Entry Delay 2:
seconds