Filter
Top Products
28
Entry/exit
doors
Your installer will program the doors you usually use to enter or exit the premises
as the entry/exit doors. These doors are programmed with entry and exit delay
times so that you can turn the system on and off without causing a false alarm.
Exit delay
time
A timer programmed by your installer. It starts when you turn on your system to
allow you a period of time to leave the premises. At the end of the exit delay time,
the system will be on.
Master code
The master code 4- or 6- digit access code, is used to set system options, to turn
the system on and off, and to program other access codes.
Stay mode
Turning on the system so that only the perimeter zones (see zone definitions,
below) are on. (Use when one or more people will stay on the premises.)
Trouble
The NT9005 controller continuously checks the system for problems. If the control-
ler finds a problem (trouble), it will indicate this at the keypad. See
Checking
Trouble Conditions
on page 16 for a list of possible trouble conditions, and how
they are displayed.
Zone
A limited area of the premises monitored by a detector (smoke detector, door/win-
dow contact, motion detector, glassbreak detector, etc.).
Perimeter zone:
A zone that detects intrusion from outside the premises (e.g.,
door contact on an outside door, glassbreak detector).
Interior zone:
A zone that detects intruders who have already entered (e.g., a
motion detector).
Fire zone:
A zone that has a heat or smoke detector.