Filter
Top Products
20
Erasing a code
1. Press [Master Code]
2. Enter the number of the code you want to erase [01 to 32]. The Master code
cannot be erased.
3. To erase the code, press .
4. To exit access code programming, press .
Setting the
Time and Date
You should make sure that your system has the correct time and date. This is
important for the auto-arm feature to function correctly, and for accurate report-
ing of events.
1. To select time and date, press [Master Code] .
2. Enter the time in hours and minutes using the 24 Hour format (00:00 to 23:59)
then enter the date in months, days and years (MMDDYY) (November 26, 2000
= 112600).
4. To exit programming, press .
Turning the
Door Chime
On or Off
If your installer has enabled the door chime feature, your NT9005 will beep when-
ever designated doors or windows are opened or closed. Your installer has pro-
grammed which doors and windows will activate the door chime.
1. Press to turn the door chime feature ON.
The keypad will beep 3 times.
2. Press again to turn the door chime feature OFF.
The keypad will sound one long beep.
The function button
Chime
can also perform the same function if it is
pressed and held for 2 seconds. When door chime is enabled the keypad will
beep 3 times. When door chime is disabled the keypad will sound one long
beep.
Changing the
Pitch of the
Keypad Tone
There are several different tones that can be programmed for keypresses and other
audible indications.
1. Press and hold . The NT9005 will cycle through the different tones avail-
able. Release the key when the tone of your choice sounds.
*
5
*
#
6
*
1
#
4
*
4
*
*
*