Filter
Top Products
14
Intrusion
(Burglary)
Alarms
A steady siren means an intrusion alarm.
To silence the alarm:
1. Enter your [access code].
2. If the alarm was unintentional, call your central station immediately to avoid an
unnecessary response.
3. Check the alarm memory to see which zone caused the alarm.
Once the source of the alarm has been identified and the problem corrected,
the system will return to the Ready state.
Checking
Alarms in
Memory
The Memory message will be displayed if there is an alarm in memory. To view
zones that have gone into alarm press . The alarm memory is cleared each
time the system is turned on. Alarms displayed by the system will have only
occurred during the last time the system was on.
CAUTION: If you return and find that there was an alarm while you were
away, it is possible that an intruder may still be on the premises. Go to a
nearby safe location, and call your central station or the local authorities to
investigate.
Calling for
Help
The NT9005 has three pairs of emergency keys. Using these keys you can send an
immediate Fire, Auxiliary or Panic message to your central station.
IMPORTANT: The Fire, Auxiliary and Panic keys will NOT function unless
they have been turned ON by the installer. If your installer has turned these
keys ON, and enabled audible feedback, holding down the keys for two
seconds will cause the keypad sounder to beep indicating that the alarm
input has been accepted and transmission to the central station is under-
way.
From the NT9005 controller
Press both keys for two seconds to send a Fire message, and to trigger a
fire alarm on the system.
Press both keys for two seconds to send an Auxiliary message.
Press both keys for two seconds to send a Panic message.
3
*