ADT Security Services NT9005 V1.0 NA Home Security System User Manual


 
10
Turning On
Your System
While You Are
At Home (Stay
Mode)
Use the Stay mode when you want to stay at home, and also want to prevent
unauthorized entry from outside. The system will only turn on the perimeter zones
(e.g., door and window contacts), and will leave the interior zones off (e.g.,
motion detectors) so that you will be free to move around inside.
1. Check that your system is ready (green Ready light is ON)
2. Enter your [access code]. As you enter each digit, the keypad sounder beeps.
If you entered the access code incorrectly, the keypad sounder will buzz steadily
for two seconds. Re-enter your access code correctly.
When you enter a valid access code:
The keypad sounds 6 fast beeps.
The red (Armed) light turns ON.
The Bypass message is displayed.
The exit delay time begins and the keypad beeps once every second. The
keypad will beep twice per second for the last 10 seconds of the exit delay
time.
3. DO NOT leave through the entry/exit door. This tells the system that you are not
leaving, and the system automatically turns off the interior zones.
At the end of the exit delay time, all keypad lights, except the red (Armed) light,
will turn OFF. The system is now on.
Re-activate bypassed zones
To turn on the rest of the system when it is in Stay mode:
1. Press or
press the
Interior
function key. The interior zones are
now on.
NOTE: When interior zones are on, you will not be able to enter areas pro-
tected by motion detectors, or open doors and windows. To access these
areas, you must enter your [access code] and turn off the system.
Stay Button
You may also be able to Stay arm your system quickly, using the
Stay
func-
tion button on your keypad.
If your installer has programmed this button
, press
and hold it for two seconds to turn your system on in Stay mode.
Turning On
Your System
With No
Access Code
(Quick Arm)
Your installer will tell you if the Quick Arm method is enabled on your system. If it
is, using the following method you can quickly turn on your system without hav-
ing to enter an access code.
1. Check that the system is ready (green Ready light is ON)
2. Press .
The keypad sounds 6 fast beeps.
The red (Armed) light turns ON.
The exit delay time begins and the keypad beeps once every second until
the end of the exit delay time.
1
*
*
0