Filter
Top Products
8
Turning Off
Your System
1. If you are outside, enter through the entry/exit door. The keypad beeps to
remind you to turn off the system.
NOTE: Entering by any other door will immediately cause an alarm.
2. Enter your [access code]. If you have entered from outside, you must enter the
correct access code before the keypad stops beeping. If you do not enter a valid
access code during this time, the system will sound an alarm.
NOTE: If you have entered the wrong code the keypad will sound one long
beep - try again to enter the correct code.
As soon as you enter the correct code, the red (Armed) light turns OFF and the
keypad stops beeping.
3. If an alarm occurred while the system was ON, the NT9005 will display the
Memory icon. See
Checking Alarms in Memory
on page 14.
CAUTION: If you return and find that an alarm has occurred while you
were away, it is possible that an intruder may still be on the premises. Go to
a nearby safe location, and call your central station or the local authorities
to investigate. The alarm memory is cleared each time the system is turned
on, so any alarms showing have occurred while you were away.
Other Ways to
Turn Your
System On
There are two basic methods for turning on your security system.
•
Away
: Use this method when everyone will be away from the premises. See
page 9.
•
Stay
: Use this method when one or more people will stay on the premises. See
page 10.
You can also use any of the following methods to turn on your system (see pages
10 to 11):
•
Quick Arming:
Turn on your system without having to enter an access code.
Your installer must turn on this feature before it will work.
•
No Entry Arming:
Turn on your system with no entry delay time - use this
method when no one else will be entering the premises.
•
Automatic Arming:
The system will turn itself on at pre-set times.
Your
installer must turn on this feature before it will work.