ADT Security Services NT9005 V1.0 NA Home Security System User Manual


 
6
Section 2: Using Your NT9005 System
Operating the
System from
the NT9005
Controller
The NT9005 controller provides a large, easy to understand LCD to help you to use
your system.
You can check the current status of your system by viewing the LCD. The NT9005
will display the time, whether the system is currently on (armed) or off (disarmed),
if any zones are currently open or bypassed (turned off), and if there are any trou-
ble conditions currently present on the system.
LCD
1 Clock Digits 1, 2
– These
two 7 segment clock digits
indicate the hour digits when
the local clock is active, and
identify the zone when the
OPEN or ALARM icons are
active. These two digits scroll
one zone per second from
the lowest zone number to
the highest when scrolling
through zones.
2 : (Colon)
– This icon is the hours/minutes divider and will flash once a second when the
local clock is active.
3 Clock Digits 3 and 4
– These two clock digits are the minute digits when the local clock is
active.
41 to 8
– These icons identify Troubles when [*][2] is pressed.
5Memory
– Indicates that there are alarms in memory.
6Bypass
– Indicates that there are zones automatically or manually bypassed.
7Fire
– Indicates that there are fire alarms in memory.
8 Program
– indicates that the system is in Installer’s Programming, or the keypad is busy.
9
Chime
– This icon turns on when [*][4] or
Chime
is pressed to enable Door Chime
on the system. Press [*][4] or
Chime
to disable Door Chime.
10 AM, PM
– This icon indicates that the local clock is displaying 12 Hr. time. These icons will
not be on if the system is programmed for 24Hr. time.
11 Away
– Indicates that the panel is armed in the Away mode. It will turn on at the begin-
ning of the exit delay.
12 Stay
– Indicates that the panel is armed in the Stay mode. It will turn on at the beginning
of the exit delay.
13 ALARM
– This icon is used with clock digits 1 and 2 to indicate zones in alarm on the sys-
tem. When a zone is in alarm, the ALARM icon will turn on, and 7 segment displays 1 and
2 will scroll through the zones in alarm.
14 OPEN
– This icon is used with clock digits 1 and 2 to indicate violated zones (not alarm) on
the system. When zones are opened, the OPEN icon will turn on, and clock digits 1 and 2
will scroll through the violated zones.