Filter
Top Products
III. PRODUCT APPLICATION
This furnace is primarily designed for
residential home-heating applications. It is
NOT designed or certified for use in mobile
home, trailers or recreational vehicles. This
unit is NOT designed or certified for outdoor
applications. The furnace
must
be installed
indoors (i.e., attic space, crawl space, or
garage area
prOVided
the garage area is
enclosed with an operating door).
This furnace can be used in the following
non-industrial commercial applications:
Schools,
Office
buildings,
Churches,
Retail
stores,
Nursing
homes,
Hotels/motels,
common
or
office
areas
In
such applications, the furnace must be
installed with the following stipulations:
o
It must be installed per the
installation instructions provided and
per local and national codes.
o It must be installed indoors in a
building constructed on site.
o
It
must
be
part of a ducted system
and not used in a free air delivery
application.
o It must not be used as a
"make-up"
air unit.
o This furnace may NOT be used as a
construction site heater.
To ensure proper installation and operation,
thoroughly read this manual for specifics
pertaining the installation and application of
this roduct.
r WARNING
Possible
property
damage,
personal
injury
or
death
due
to
fire,
explosion,
smoke,
soot,
condensation,
electrical
shock
or
carbon
monoxide
may
result
from
improper
installation,
repair,
operation
or
maintenance
of
this
product.
r WARNING
To
prevent
personal
injury,
property
damage
or
death
due
to
fire,
do
not
install
this
furnace
in
a
mobile
home,
trailer
or
recreational vehicle.
To ensure proper fumace operation, install,
operate and maintain the furnace in
accordance with these installation and
operation instructions, all local building
codes and ordinances.
INSTALLATION CODES
INSTALLATION MUST COMPLY WITH
THE REQUIREMENTS OF AUTHORITIES
HAVING JURISDICTION.
All local and national codes governing the
installation
of
oil burning equipment,
Wiring,
and venting must be followed. Some of the
applicable codes are:
CAN/CSA B139 Installation Code for Oil
Burning EqUipment.
NFPA
31
Installation Code for oil Burning
Equipment
ANSIINFPA 90B Warm Air Heating and Air
Conditioning Systems.
ANSIINFPA 70 National Electrical Code.
CSA
C22.1 Canadian Electrical Code.
ANSI/NFPA
211
Chimneys, Fireplaces,
Vents and Solid Fuel Burning Appliances.
A copy of the CAN/CSA B139 Installation
Codes can be obtained from:
CSA International
178 Rexdale Boulevard
Etobicoke, Ontario, Canada M9WIR3
or
CSA International
8501
East Pleasant Valley
Cleveland, OH 44131
The rated heating capacity of the furnace
should be greater than
or
equal to the total
heat loss
of
the area to be heated. The total
heat loss should be calculated by
an
approved method
or
in accordance with
"ASHRAE Guide" or "Manual
J-load
Calculations" published by the Air
Conditioning Contractors of America.
IV. LOCATION REQUIREMENTS
&
CONSIDERATIONS
GENERAL
r WARNING
TO PREVENT POSSIBLE EQUIPMENT
DAMAGE, PROPERTY DAMAGE,
PERSONAL INJURY
OR
DEATH, THE
FOLLOWING BULLET POINTS MUST
BE
OBSERVED WHEN INSTALLING THE
UNIT.
4