Acu-Rite 08551W Home Safety Product User Manual


  Open as PDF
of 1
 
Replace the Battery
1. Open the ashlight by twisting the
cap counter clockwise.
2. Remove the plastic sleeve containing
(4) “LR 41” button cell batteries.
3. Remove the batteries from the plastic
sleeve, making sure to note the
orientation of the batteries before
removing them from the sleeve.
4. Place (4) new batteries into the
plastic sleeve, making sure that each
new battery is facing “-“ side up.
5. Replace the plastic sleeve with the
new batteries into the ashlight, with
the “+” side facing down and the “-“
terminal facing up.
6. Replace the cap by twisting it
clockwise, making sure not to
overtighten.
Quick Start Guide
Carabiner Flashlight
model 08551W, 08552W, 08553W
SAVE THIS MANUAL FOR FUTURE REFERENCE.
4
5
6
PLEASE DISPOSE OF OLD OR DEFECTIVE BATTERIES IN AN
ENVIRONMENTALLY SAFE WAY AND IN ACCORDANCE WITH YOUR
LOCAL LAWS AND REGULATIONS. BATTERY SAFETY: Follow the polarity (+/-) diagram in
the battery compartment. Promptly remove dead batteries from the device. Dispose of used batteries properly. Only batteries of
the same or equivalent type as recommended are to be used. DO NOT incinerate used batteries. DO NOT dispose of batteries in
fire, as batteries may explode or leak. DO NOT mix old and new batteries or types of batteries (alkaline/standard). DO NOT use
rechargeable batteries. DO NOT recharge non-rechargeable batteries. DO NOT short-circuit the supply terminals. Battery contains
mercury. Do not put in trash. Recycle or manage as hazardous waste.
Questions? Contact Customer Support at
(877) 221-1252 or visit www.AcuRite.com.
Congratulations on your new AcuRite product. To ensure the best
possible product performance, please read this manual in its
entirety and retain it for future reference.
Specications
POWER
4 x "LR 41" (included)
Getting Started
Please note that the carabiner ashlight
ships with a plastic safety insert located in
the battery compartment. This safety insert
helps conserve energy while the product
is being stored, packaged and shipped.
Simply remove the small plastic insert so
that the carabiner ashlight will be able to
function properly.
1. Twist the cap of the ashlight assembly
counter clockwise.
2. Remove the small plastic disc that covers
the battery sleeve.
3. Replace the cap by twisting clockwise,
making sure not to over-tighten.
Instructions for Use
NOTE: Carabiner Flashlight is not intended for load-bearing
activities and should not be used for climbing.
1. To power on the ashlight, twist the cap clockwise until the light
illuminates.
2. To power off the ashlight, twist the cap counter clockwise until
the light shuts off.
3
Printed in China
08551W INST 052413
Safety Information
This Carabiner Flashlight is not designed for load-bearing
activities and should not be used for climbing.